Never one to pass up the recycle pile at work, [Scott] usually doesn’t find much. A few old hard drives, maybe a ancient laptop every once in a while, but on very rare occasions he finds something ...

grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

Makers, developers and Arduino enthusiasts searching for silent stepper drivers with high resolution encoders which are also Arduino compatible. May be interested in the new range of uStepper S line ...

For his entry into the 2019 Hackaday Prize, [Tobius Daichi] is working on adding some motion control capabilities to everyone’s favorite Linux SBC. His 3+Pi board attaches to the Raspberry Pi’s GPIO ...

Electronic enthusiasts may be interested to know that a four axis stepper motor driver designed specifically for “creative coders” is now available from the Crowd Supply website. The STEP400 is ...

The Stepper 28 Click smart stepper controller board and support tools simplify development of motorized systems used in ...

Both the AMIS-30621 and AMIS-30622 integrate a bus connection, positioning and control electronics and a motor driver in a single 32-pin, 'near chip scale' NQFP package with a profile of under 1mm and ...

This Design Idea further develops a previous one integrating a stepper-motor driver in a CPLD (Reference 1). However, this idea integrates not only the driver, but also a simple one-axis stepper-motor ...