An interesting Arduino project has been published to the Instructables website showing how an Arduino CNC shield and controller has been used to create an awesome 3 axis Arduino CNC plotter. The ...
How do I write firmware for it to access an ISA card? If you're not sure, this project might not be applicable to your use case. In short, take a look at these pages ...
Modern EPROM programmers like the TL866 are unable to read the 28 pin 1Mbit ROM used in the BBC Master. If you are troubleshooting a BBC Master and you don't have a known good BBC Master to test the ...
Abstract: This paper shows how to design and building low cost Arduino plotter machine based on the open source hardware and software. The Arduino plotter machine has been dependent on the principle ...
Abstract: A CNC plotting device capable of producing or constructing mechanical components in accordance with design software.. The use of CNC machines is increasing quickly as technology in ...
The folks over at NKC electronics didn’t waste any time with this one. They sent in the MEGA shield for the Arduino MEGA. We just posted the story of the Arduino MEGA yesterday, so that was pretty ...
Once, long ago when magazines still existed, I bought a copy of Popular Mechanics. Inside was a guide on how to build a robotic lawnmower. Now this was back in the 1980s so it wasn’t a very complex ...
Using a little Arduino hardware and programming a new CNC printing machine has been created to help bring Batik designs to life. Batik is a fabric decoration technique where wax is applied by hand to ...
Some results have been hidden because they may be inaccessible to you
Show inaccessible results
Feedback