Pocatello, Idaho — AMI Semiconductor has introduced two single-chip stepper motor driver ICs that are said to significantly reduce component count and bill of materials (BOM) cost in dynamic motion ...

Mikroe has added a smart 85V 10A stepper motor driver to its range of interchangeable ‘Click’ boards. Called Power Step 2 Click, the board “is based on the powerSTEP01, a 1/128 microstepping ...

Kevin Teresa based in Switzerland has created a new open source stepper motor driver board with 6A / phase and 48V capabilities enabling it to drive a wide variety of stepper motors from NEMA 17 to ...

It didn’t take long to figure out that a dead X axis and an message saying “TMC CONNECTION ERROR” meant that one of the stepper drivers on the SKR E3 Mini 3D printer control board had released the ...

When you think about highly-precise actuators, stepper motors probably aren’t the first device that comes to mind. However, as [Diffraction Limited]’s sub-micron capable micro-manipulator shows, they ...

TRINAMIC Motion Control's new TMC2660 stepper motor driver IC supports motor drive currents up to 4A. The new IC integrates both a pre-driver for real-time calculation of motor coil current values, ...

The project illustrates the control of two unipolar stepper motors using this circuit in full step mode through the RS232 serial port of the PC. The signals from the serial port of the PC is being ...

grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...