⇒ UART Configuration : One of the most powerful aspects of the TMC2209 is its single-wire UART interface. With UART, you can configure motor current, microstepping resolution, operating modes, and ...

grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

This library implements non-blocking functions to move a stepper motor by jogging (start/stop on command), or by a set angle (absolute or relative). Constant speed ...

This library enables you to use Hardware-based PWM channels on Arduino AVRDx-based boards (AVR128Dx, AVR64Dx, AVR32Dx, etc.), using DxCore, to create and output PWM. Using similar functions as many ...

今回は、Arduinoとステッピングモータ（28BYJ-48）を使って、スイッチで回転制御する実験を行ったので、備忘録としてまとめておきます。 通常の順番（IN1, IN2, IN3, IN4）と異なり、ここでは MOTOR_1, MOTOR_3, MOTOR_2, MOTOR_4 の順に指定しています。 これはライブラリ ...

Never one to pass up the recycle pile at work, [Scott] usually doesn’t find much. A few old hard drives, maybe a ancient laptop every once in a while, but on very rare occasions he finds something ...

Hackers always have their eye out for a good deal, so when [Gadget Reboot] saw a good price on square stickers he had to pull the trigger. There was just one problem: his logo is a circle. He could ...